Add On Shock Sensor To Factory Alarm. Because the factory alarm did not come with a glass shock sensor. Tilt sensor (reads car angle at shutoff and then will trigger on tilt angle change;
I am trying to add a shock sensor to the factory alarm. Open up your dei 504d bag, and you'll have a sensor and a harness. The sensor works perfectly and i feel better knowing that i’ve made theft just a little bit harder.
Use The Coupons Before They're Expired For The Year 2022.
When i roughed the install in to test it and had everything just laying in the back floor board just a little peck on the window would activate the shock sensor. The sensor works perfectly and i feel better knowing that i’ve made theft just a little bit harder. But i am having trouble locating the correct wire for the car’s door sensor.
The Shock Sensor Acts As A Switch When Hooked Up To Power (Red) And Ground (Black).
The hockey tape fabric was a close facsimile to the factory. 2021 hydro blue ram trx. One relay is already closed, and the other closes in response to the shock sensor activating.
There Are Three Types Of Sensors For Alarms That Are Not Included In The Hellcat:
Be sure to turn the sensitivity all the way up on the shock sensor via the screw adjustment on the sensor. Cut off the one end of the sensor harness. Open up your dei 504d bag, and you'll have a sensor and a harness.
The Hood Switch Would Be The Easiest.
I was able to locate good sources for continuous and ignition power. Because the factory alarm did not come with a glass shock sensor. I am trying to add a shock sensor to the factory alarm.
Open Door Without Unlocking The Truck.
The shock sensor would provide a ground closure when activated and would set off the alarm as if the hood had been opened. After activation the dic would show that the alarm was triggered. Go out to your car, and place the shock sensor and its harness in the driver seat.
Share
Post a Comment
for "Add On Shock Sensor To Factory Alarm"
Post a Comment for "Add On Shock Sensor To Factory Alarm"